Short bolt + nut
The combination of the short bolt and nut allows profiles to be installed from the front. The connection consists of a nut suitable for the relevant profile module and an Allen screw. To create the connection, a through-hole for the Allen key must be made. Ensure that the screw is long enough so that its end does not touch the bottom of the groove, to ensure correct assembly. This type of connection is often used for sliding elements. Thanks to easy access to the screw and the very smooth sliding of the profiles on the hard anodised surface, adjusting the position of the component is much more efficient than with a quick-release connection. The connection also allows components to be fitted at any angle.
Tools and components for assembly
| Module | Tools required | Assembly components |
|---|---|---|
| M20 R5 | Drill bit D = 5 mm, Allen key | 200508.3 + 211252 |
| M30 R6 | Drill bit D = 6 mm, Allen key | 200612.1 + 210652 |
| 200612.1 + 210650 | ||
| M30 R8 D5.5 | Drill bit D = 6 mm, Allen key | 200610.2+210036 |
| 200610.2+210609 | ||
| M30 R8 D7.3 | Drill bit D = 6 mm, Allen key | 200610.2+210036 |
| 200610.2+210609 | ||
| M40 R8 | Drill bit D = 7,3 mm, Allen key | 200816 + 210482 |
| M40-I R8 | Drill bit D = 7,3 mm, Allen key | 200816.3 + 210482 |
| 200816.3 + 210208 | ||
| M40 R10 | Drill bit D = 7,3 mm, Allen key | 200816.2 + 210082 |
| 200816.2 + 210080 | ||
| M45 R8 | Drill bit D = 7,3 mm, Allen key | 200816.1 + 210802 |
| 200816.1 + 210800 | ||
| M45 R10 | Drill bit D = 7,3 mm, Allen key | 200816.2 + 210082 |
| 200816.2 + 210080 | ||
| M50 R10 | Drill bit D = 7,3 mm, Allen key | 200816.2 + 210082 |
| 200816.2 + 210080 |
